Views: 0 Author: Site Editor Publish Time: 2023-05-08 Origin: Site
The production line of aluminum plant is an industrial environment with high dust and flue gas. In the production process of aluminum products, a large number of particulate matter and gas pollutants are produced. These pollutants can have a serious impact on employee health and the environment, so it is essential to introduce a dust removal line. This paper will introduce the dust removal production line of Xuzhou Runkun Aluminum factory.Xuzhou Runkun Aluminum Industry Co., Ltd. Introduces Revolutionary Aluminum Profile Painting Line. This cutting-edge technology brings a multitude of product features and advantages, revolutionizing the way aluminum profiles are finished and protected in architectural applications.
1. Simple process, effectively reduce the difficulty of process operation
2. High yield of finished products, maximum control of unqualified products
3. Energy consumption is obviously reduced
4. Reduce water and air pollution, effectively improve the competitive strength and output ratio of aluminum profiles
5. Adopting automatic assembly line operation, the way of loading and the way of using fixture have been obviously simplified, which improves the production efficiency and reduces the labor intensity.
6. The standard of surface quality requirement of raw material has been significantly reduced, and the powder coating can completely cover the extrusion pattern on the surface of the profile, cover part of the defects on the surface of the aluminum profile, and improve the surface quality of the finished aluminum profile.
7. Some physical indicators of the coating film are significantly improved compared with other surface treatment films, such as hardness, abrasion resistance, acid resistance, which can effectively extend the service life of aluminum profiles.
Aluminum material is soft, so it is easy to produce top damage, crushing damage, scratching, deformation during stamping production, in addition to the requirements on the mold, the following points should be done during stamping production:
1. In order to do a good job of stamping aluminum parts and reduce the defective rate, we must first do a good job of 5S, especially cleaning, including mold, punching table, assembly line and packaging materials must be free of sharp debris, no dirt and regular clear cleaning, mold must be cleaned up and down, no debris.
2. Found that the product burr is large, it must be timely sent to the mold repair and follow up to the result.
3. Aluminum parts are easier to heat, and backlog together to harden, so when punching and blanking, it is necessary to apply some pressure oil on the material (which can dissipate heat and smooth dredge blanking) and then press.
4. The products with more punching need to be punched to clean the surface of the mold, so that the mold and the product are always clean and free of debris, and the crowning injury is reduced. It is found that the crowning problem point of the mold must be found and solved before the production can continue.
5. Pushing the mold pushing block will produce aluminum chips, so the aluminum chips under the pushing block must be cleaned after the production of the pushing block every day